This harness is designed to feed low impedance injectors in race applications. Using direct feed from the positive bus, the…
ECM coolant temperature sensor. Fits all 1980-1995 GM engines. Please specify application when ordering. Check out our complete section of…
Engine temperature sending unit.For gauges or warning lights. We handle any sending unit you might need for your GM car…
4 Wire Heated Oxygen (O2) Sensor Replacement 103008 Denso 4 Wire sensor Blk Sq Four wire heated o2 sensor, made by DENSO, and very active. Currently…
Heated O2 Sensor Kit ONLY 86/87 Wiring Harness Plug-and-Play harness installs in minutes with NO wires to cut or splice. Harness…
The most advanced datalogging scantool available today for the 86/87 Turbo Buicks and 89 TTA's. Connects to USB port on…
These AEM Power replacement wideband O2 sensors are used in AEM single channel UEGO systems. They may also work with…
If you have a Powerlogger, this can be connected to monitor and datalog air/fuel ratio.
The Inline Wideband UEGO gives all…
The factory positive cable is obsolete. We manufacture ours to better than factory specifications, we then add extra length to…
Absolutely essential upgrade item for your turbo car! Increases fuel pump volume by 15% or more! By far the finest…
Factory appearing Fuel Injector harness using 14 gauge wire, recommended for use in high performance racing applications where low impedance…
Eliminate electrical "gremlins" with a new cable. Our negative cable is manufactured to OEM specifications, using the new "slip-over" terminal…
Replaces damaged connectors for fuel pump/sender. Kit contains two mating connectors with wiring. similar to our GN tank kit except…
Same as ECM Memory Splice Both Ends 1984 / 1987 GN, but fits 1989 TTA using TWO brown wires. Price $8.95 …
This connector is found on the positive battery cable, 89 TTA, and contains two fuse links. Feeds the ECM MEM…
Located on the engine harness, 89 TTA, connects to the positive battery cableand provided two 12 gage feeds. Frequently a…
Enables addition of SPAL dual fans to the turbo Trans-Am. Plug-and-Play. Price is $30.95…
Location: Starter stud. Replace blown/broken/corroded fusible links with thisreplacement kit; 4 links go to 5-12 gage wires.
Price is $22.95
…
This Plug-And-Play adapter module is designed to permit the XFI Fuel Management Computer to directly interface with the electrical system…
Plug-in device amplifies tach signal from CCCI ignition system which would otherwise not drive a typical aftermarket tachometer. 3 wires…
