Fits 86-87 Turbo Buick & 89 Turbo Trans am 150 amps up to 170 Alternator Model:…
This Plug-And-Play adapter module is designed to permit the XFI Fuel Management Computer to directly interface with the electrical system…
The Scanmaster has been the must-have device for all Turbo Buick owners since 1993!! Now updated to 21st century technology!!…
The most advanced datalogging scantool available today for the 86/87 Turbo Buicks and 89 TTA's. Connects to USB port on…
If you have a Powerlogger, this can be connected to monitor and datalog air/fuel ratio.
The Inline Wideband UEGO gives all…
We now have a kit that will replace your high lowand delay fan relays. This replaces all of the fan…
We now have a kit that will replace your high lowrelays. This replaces all of the fan relays on the…
This harness is designed to feed low impedance injectors in race applications. Using direct feed from the positive bus, the…
Used in dyno applications where the lengths of each connector are equal. Also can be used for sheet metal intake…
Factory appearing Fuel Injector harness using 14 gauge wire, recommended for use in high performance racing applications where low impedance…
These AEM Power replacement wideband O2 sensors are used in AEM single channel UEGO systems. They may also work with…
The factory positive cable is obsolete. We manufacture ours to better than factory specifications, we then add extra length to…
Battery Positive Extender Heavy Duty This specially built kit is designed to: 1) to re-locate the fuse links from the starter…
Plug-And-Play unit inserts between your TPS sensor and TPS wiring. It has two functions; one, it allows you to calibrate…
CCCI Ignition Harness 86/87 This harness is designed to power up the CCCI ignition system components for use on other applications…
Dual Fan Relay Harness Use this relay harness when installing a GBP dual fan assembly. This takes the excessive electrical…
Absolutely essential upgrade item for your turbo car! Increases fuel pump volume by 15% or more! By far the finest…
4 Wire Heated Oxygen (O2) Sensor Replacement 103008 Denso 4 Wire sensor Blk Sq Four wire heated o2 sensor, made by DENSO, and very active. Currently…
Cam Sensor Balance Kits. Even in new condition the factory cam sensor is out of balance and has an inherent vibration…
Heated O2 Sensor Kit ONLY 86/87 Wiring Harness Plug-and-Play harness installs in minutes with NO wires to cut or splice. Harness…
